◼lntegrated injection molded housing with high mechanical strength

IP67 High protection

◼Small size , thickness only 16mm , wide applicability

◼The installation is simpIe and convenient

International Certification Specifications

safety specifcation certifcation Rating

CCC(GB/T14048 . 5) 、 TUV(IEC60947-5- 1)

characteristics

operating characteristics

The sealing material can  lt can spoil.  please conirm the actual  usage conditions bef  re determining the maintenance and  replacement time.

please install the switch in a location that will not directly come into contact with chips or dust.  It is necessary to ensure that the drive , The

moving rod and switch body will not accumulate cutting chips and mud like substances.

when the switch is subected to continuous vibration and impact, the generated wear powder may cause contact connection poor contact,

abnormal movement , decreased durability and other issues. In addition , if there is excessive vibration And impact, which may cause contact

maIfunction and damage , so please install it in the In a position that will not be subected to vibration and impact, and in a direction that will not

resonate.

The switch has physical contacts  .f silicon 9as is present in the environment, the arc energy will cause silicon dioxide (sio2) accumulates on

the contacts , resulting in poor contact.

There issiicone olaround the switch when using silicon illers , silicon wires , and other silicon products , PIease use contact protection circuits to

suppress arcing And eliminate the source of silicon as 9eneration.

operate

The perating method , shape of the cam or stop , operating frequency and overtravel all significantIY afect the ser  ice Iife and the accuracy of

the limit switch. Due to this reason , the angle of the stop must be below 30    , the surface roughness of the stop must be above 6 . 3 S , and the

hardness must be Hv 400 to 500 .

To ensure the correct movement of the plunger type drive rod , adjust the stop and cam to the correct setting position. The correct position is the

position where the plunger groove matches the top of the sleeve.

To allow the ba lswing rod type drive rod to move correctIY adjust the stop and cam so that the arrow is positioned between the two protruding marks , as shown below.

on the use of small Load Models

The use of a general load switch in the switching of a small load circuit will cause contact failure.The use of small load type,if the switch willoccur surge current load,will also aggravate the contact consumption,shorten the service life,so please insert the necessary contact protectioncircuit.The minimum applicable load is the N-level reference value.This represents the level of the fault level at a reliability level of 60%(Iλ60).

λ60=0.5x10-6/time indicates that the presumed failure rate is less than 1/2,000,000 at a reliable level of 60%.

precautions for use

switch contacts can be used f  r general loads or small loads.  However, contacts that have already been connected to general loads cannot be

used to connect sma ler capacity Iads. otherwise , it may lead to roughness of the contact surface and loss of contact reliability.

Mounting hole

plunger type may malfunction due to harsh environments , such as dust or cutting debris causing poor reset.  In this case , please use a model

with a rubber cap.

Do not come into contact with water exceeding 70   C Or use under steam .

Tighten each screw to the corresponding toraue according to the tabIe below 

BY removing two screws from the  head ,  the  head direction  can  be  rotated  180  °  .  when  changing the direction  of the head Then tighten to the torque speciied above. Be careful not to allow any impurities to enter the switch.